Amorphous Submicron Layer in Depletion Region: New Approach to Increase the Silicon Solar Cell Efficiency

Authors

  • A. V. Kozinetz Taras Shevchenko National University of Kyiv, Institute of High Technologies (64, Volodymyrs’ka Str., Kyiv 01601, Ukraine)
  • V. A. Skryshevsky Taras Shevchenko National University of Kyiv, Institute of High Technologies (64, Volodymyrs’ka Str., Kyiv 01601, Ukraine)

DOI:

https://doi.org/10.15407/ujpe63.01.0038

Keywords:

amorphized layer, space charge region, n –p silicon solar cell

Abstract

The insertion of a thin amorphized layer (AL) in the space charge region of a silicon solar cell is proposed as a way to improve the conversion efficiency due to the impurity photovoltaic effect. Previously, this approach had been applied to a cell with a layer inserted in the emitter by the ion implantation. The insertion of such layer in the space charge region is founded to be preferable, because a better control over the recombination (via energy levels in the band gap and local states of interfaces) can be achieved. The parameters of a modified device are investigated by the numerical simulation, and it is concluded that the layer parameters have a crucial influence on the cell conversion efficiency. Based on our simulation results, the optimal AL and the height of barriers are determined. In such a case, the short circuit current density is improved due to the absorption of photons with energy less than a silicon band gap of 1.12 eV in AL, whereas the open circuit voltage and fill factor remain unchanged. Theoretically, the increase in the efficiency by 1–2% is achievable. In the non-optimal case, the degradation of a short circuit current and the fill factor eliminate the positive effect of an additional photogeneration in AL.

Downloads

Published

2018-02-01

Issue

Section

Semiconductors and dielectrics

How to Cite

Amorphous Submicron Layer in Depletion Region: New Approach to Increase the Silicon Solar Cell Efficiency. (2018). Ukrainian Journal of Physics, 63(1), 38-48. https://doi.org/10.15407/ujpe63.01.0038

Most read articles by the same author(s)